RX-7 x 300w Endstufe

 

RX-7

Equipped with gold-plated speaker output connectors, the rear panel includes selectable balanced XLR and RCA input connectors. A trigger input connector allows the RX-7 amplifiers to be controlled by a preamp/processor such as the Lexicon MC-12HD or MC-8. The RX-7 employs the same advanced optically-coupled protection circuitry found in the ZX-7, keeping it and associated equipment safe during adverse operating conditions.

Designed for the enthusiast, The RX-7 is the perfect complement to our award-winning Digital Controllers & Disc Transports, providing both power and refinement for today's most advanced listening systems.
 
  • 200 watts per channel (8ohm)
  • 300 watts per channel (4ohm)
  • Compatible with 2 ohm loudspeaker impedances
  • Full Balanced Topology
  • Completely symmetrical circuit design
  • Dual oversized toroidal transformers
  • Advanced optically coupled protection for each channel
  • Thermal protection from overheating
  • Loudspeaker protection from DC and frequencies below 10Hz
  • Protection against short-circuits, device failures, miswiring and internal faults
  • Stable with mismatched, reactive or unusual loads
  • Large heat-sinks for silent convection cooling
  • Balanced & single-ended input connectors
  • Trigger input for power control from an external device
  • 4 hand-graded outputs per channel
  • High power-supply voltage for extra headroom at the outputs
  • Heavy-duty gold plated output connectors
  • Rack mount option available
  • Height – 4U
 
Audio Inputs and Outputs:
Inputs

7 RCA, 7 XLR
Outputs 7 pairs of heavy-duty, gold-plated binding posts
 
Performance:

Output Power

200W RMS per channel into 8Ohm from 20Hz to 20kHz
300W RMS per channel into 4Ohm from 20Hz to 20kHz

Minimum Speaker Impediance

 4 Ohm

Frequency Response

 20Hz to 20kHz +0.1dB/-0.5dB
10Hz to 40kHz +0.1dB/-1.5dB
THD Less than 0.05% at full power ratings

Signal-to-Noise Ratio

 Greater than 100dB, ref 200W/8 Ohms (30kHz bandwidth)

IM Distortion

 Less than 0.05% at full power ratings
Crosstalk Greater than -60dB @ 1kHz (30kHz bandwidth)

Damping Factor

 Greater than 400 @ 10Hz to 400Hz

Input Sensitivity

 1V for 100W out @ 8

Input Impedance

 Minimum 10K
Gain Minimum 28dB
 
Other:

Trigger Input

 3.3 to 24 Volts DC ± 10%, 3.5mm T/S jack

Power Requirements

 120V 60Hz 12 Amp (domestic)
230V 50Hz 7 Amp (export)

 
QR-Code